4/98
SED2D-WES Version 4.3 Beta
An example interactive session follows. The input file "claysed.sed" is supplied with the SED2D-WES source
code.
C:\SED2D>
sed2dv43.exe
To receive a response menu, type ?.
ENTER RUN CONTROL INPUT FILE NAME
claysed.sed
ENTER FULL PRINT OUTPUT FILE NAME
claysed.out
ENTER INPUT GEOMETRY FILE FROM GFGEN (binary)
madora.gbn
ENTER INPUT RMA2 HYDRODYNAMIC FILE (binary)
madora.sol
ENTER OUTPUT CONCENTRATION/DELBED FILE (binary)
claysed.cd
ENTER OUTPUT BED STRUCTURE (binary)
claysed.bs
ENTER OUTPUT GEOMETRY CONTAINING NEW BATHYMETRY (ascii)
claysed.geo
The program now will run. Some information will be written to the screen as the program progresses. If the
process finishes normally, the prompt appears. Check that the files that you requested to be created were saved.
Output files will be saved to the same directory from which the program was launched. If the process does not
finish normally, an error message will be written to the screen. Examine the error message carefully to determine
the cause of the error. Also check the bottom of the full print file ("claysed.out") to find clues about when and how
the program was aborted.
Displaying your results with FastTABS
This version of SED2D-WES was designed to run with the SMS Graphical User Interface. If you are using
FastTABS (the predecessor to SMS) you must first run a conversion program to convert your SED2D-WES output
to a format that is compatible with FastTABS. The conversion program is written in FORTRAN and is called
"v12_2_ft.f". The compiled version of this program is typically called "v12_2_ft.exe". You will be prompted at
the terminal for the input data required to run this program. The input is self-explanatory. Simply answer the
questions as they appear on the screen. The following is an example interactive session to run "v12_2_ft.exe":
80
WORKING DRAFT
Previous Page
