07/00
TABS-MDS
$S CARD
SEDIMENT TRANSPORT FILE CONTROL
$S CARD
Required
Active parameters on this card cause the program to read from or write to the requested file.
Field
Variable
Value
Description
0,C1-2
IC1
$S
Card group identifier
1
NBSI
+
Read bed structure hotstart file (File code = 23)
0
Do not read bed structure hotstart file
2
NBSO
+
Write bed structure hotstart file (File code = 24)
0
Do not write bed structure hotstart file
3
NNG
+
Write ascii geometry file. Reflects the bed geometry at the end of the
run (File code = 25)
0
Do not write ascii geometry file.
Note: the bed structure hotstart file will hotstart the bed layer thicknesses and bed sediment concentrations ONLY
(i.e. it will not hotstart the delbed , the suspended sediment concentration, or the hydrodynamics). If a standard
hotstart file is read in in addition to the bed structure hotstart, the bed layer thicknesses and the bed sediment
concentrations given in the bed structure hotstart will overwrite those values given in the standard hotstart.
5
Previous Page
